Scan Auto

ScanStation tab

This tool communicates with the scanner to perform scans and compare them with a reference scan at a specified interval.

3D monitoring dialog

The following parameters are required:

  • Scan parameters:
    • Scanner serial number: scanner serial number. Consult the device documentation to locate it.
    • Project name: scanner project used to store the scan. Created if it does not exist.
    • Scanning Mode: Speed, Distance, Medium distance or Long distance.
    • Scanning Precision: Normal or High.
    • Scanning Resolution: available resolutions at a distance of 10 m:
      • 50 mm
      • 25 mm
      • 12.5 mm
      • 6.3 mm
      • 3.1 mm
      • 1.6 mm
      • 0.8 mm
    • Double Scanning:
    • Minimum azimuth: minimum horizontal angle relative to the scanner's horizontal circle zero, in degrees. Minimum 0.
    • Maximum azimuth: maximum horizontal angle relative to that zero, in degrees. Maximum 360.
    • Minimum Elevation: minimum vertical angle from horizontal, in degrees. Minimum -90.
    • Maximum Elevation: maximum vertical angle from horizontal, in degrees. Maximum 90.
  • Output parameters:
    • Include intensity: includes each point's recorded intensity.
    • Environmental Correction:
    • Mixed Pixels:
    • Include colour:
  • Frequency: interval in hours and minutes between scans.
  • File for projection:
    • Name: reference model file to compare with the new scan.
    • Resolution at 10 m: distance step for comparisons.
  • Output documents:
    • Point cloud: creates a point cloud containing points where differences were found.
    • Vector boundaries: creates vector boundaries grouping points where differences were found.
  • Output document parameters:
    • Tolerance: minimum and maximum differences to consider.
    • Codes: codes for storing negative and positive difference areas, respectively.
    • Min. Area: minimum area for a region to be considered.
  • Output setup:
    • Name: file name.
    • Type: file type.
    • Report: generates an ASCII report if desired.
    • Folder: folder storing the report and scan.