Triangulation

Triangulation

To run this tool from the command line, enter:

MDTop [archivo de entrada] /TRI [archivo de salida]

The input file must contain the topographic or mapping information used to calculate the digital model. It can be a TopCal point file, DIGI drawing, AutoCad DXF drawing, MicroStation drawing or ASCII file containing X, Y, Z coordinates.

The output file specifies where to save the triangulation and should have the MDT extension.

To configure triangulation, MDTop.INI must also contain the mandatory [Triangulación] line followed by:

  • CodTri: code used to store triangles.
  • CotaMaxima: maximum elevation in meters for entities included in the digital model.
  • CotaMinima: minimum elevation in meters for entities included in the digital model.
  • HayRupturas: 1 to include breaklines, or 0 for no breaklines.
  • Código[n]: sequence of codes included in the model, where n is a consecutive number starting at 1.
  • Ruptura[m]: sequence of breakline codes, where m is a consecutive number starting at 1.
  • ExcluirCodigo[p]: sequence of codes to exclude from the model, numbered consecutively from 1.
  • ExcluirRuptura[q]: sequence of codes not to use as breaklines, numbered consecutively from 1.
  • NoUnirCurvas: 1 to avoid joining contour lines during triangulation, or 0 to do nothing.
  • Equidistancia: original contour interval in meters, used when avoiding contour line joining is enabled.
[Triangulacion]
CodTri = TRIANGUL
CotaMaxima = 950.5
CotaMinima = 0.01
HayRupturas = 1
Codigo1 = 020123
Codigo2 = 020124
Codigo3 = 060140
Ruptura1 = 020124
Ruptura2 = 060140
NoUnirCurvas = 0
Equidistancia = 1

Field names are case-insensitive.

See also: