MOVE DOWN_Z

Lower cursor Z by the configured contour interval.

Parameters

Does not accept parameters.

Notes

Set the interval in the DigiNG New project dialog box or with EQUIDISTANCE.

Use when stereoplotting contour lines. After completing one contour, raise or lower recording Z by one interval to start the next.

Subtract the interval from current cursor Z without rounding to an interval multiple. Move the cursor to the new Z even if Z is locked. If FIXZ is enabled, also assign the new Z to Z.

Command characteristics

Command type Immediate command
Repeats automatically No
Menu option Immediate/Z Coordinate/Lower Z coordinate to the multiple of the previous equidistant
Toolbar Z Coordinate
Extension DigiNG.OrdenesStandard.dll
Implementation Native
Related variables EQUIDISTANCE — contour interval
FIXZ — lock the Z coordinate to a multiple of the contour interval
Z — active Z coordinate value
Related commands MOVESUP_Z
Internal name {416EF674-CB78-4121-8671-A076F25B2763}