CONFIGURE_SHOW_CONTOUR_PASS

Configure the tolerance and codes used to display contour crossings (variable SHOW_CONTOUR_PASS).

Parameters

Parameter number Description Optional
1 Z tolerance, in the same units as the drawing files' Z coordinates. Use a decimal point. Yes
2...n Codes of the lines to analyze. Support the * wildcard. A parameter starting with # is replaced by all codes assigned that tag in the code table. Yes

The command only uses parameters if it receives at least two (the tolerance and one code). With fewer than two, it displays the dialog box.

Notes

  1. The dialog box is Select codes, with a Tolerance field below the list. The first time, the list is empty, and the tolerance is 0.2. On subsequent runs, it displays the configured codes and tolerance. Canceling the dialog box retains the previous configuration.

    CONFIGURE_SHOW_CONTOUR_PASS dialog box

  2. The configuration lasts until Digi3D.AI closes: it is not saved and is shared by all drawing files.

  3. When finished, the command recalculates marked spans with the new configuration.

  4. With the variable enabled and Z locked, the program marks spans of undeleted line entities in all loaded drawing files that have any of the codes and whose Z range contains the active Z. For each line, it marks portions whose Z is between active Z minus tolerance and active Z plus tolerance.

  5. Spans are recalculated whenever Z, FIXZ, MOVESUP_Z, or MOVE DOWN_Z changes Z or the Z lock. LOCK_Z does not recalculate them.

  6. Spans are drawn as an animated red and white dashed line with a mark at each vertex, in the drawing and photogrammetric windows. They are not part of any drawing file or selection and cannot be edited.

Command characteristics

Command type Immediate command
Repeats automatically No
Menu option Immediate/Snaps/Configure curve pass...
Toolbar Snap (Show curve pass button drop-down)
Extension DigiNG.OrdenesStandard.dll
Implementation Native
Related variables SHOW_CONTOUR_PASS — enable or disable the display of contour crossings
Related commands FIXZ, Z
Internal name