SPR_XYZ

Extend or trim an entity to a boundary, setting the adjusted endpoint's Z to the boundary Z.

SPR_XYZ: select the boundary (1) and line (2); extend the line to the boundary and set its new endpoint Z to the boundary Z at the intersection, 105 between 110 and 100

Parameters

Does not accept parameters.

Notes

First select the boundary line, then lines to adjust. Each adjusted line must belong to the current model. Use the line selection point to choose the endpoint to adjust, and move it to the boundary intersection:

  • If the line falls short of the boundary, extend it.
  • If it overshoots, trim it.

The adjusted endpoint takes the boundary Z, interpolated along the boundary segment containing the intersection.

After adjusting a line, continue requesting lines with the same boundary. Press Esc to discard the boundary and request a new one. Press Esc with no boundary selected to end.

If quality control rejects the modified entity, retain its original unchanged.

Command characteristics

Command type Interactive command
Repeats automatically Yes
Menu option This command has no associated menu option
Toolbar This command has no associated toolbar button
Extension DigiNG.OrdenesStandard.dll
Implementation Native
Related variables REPEAT — repeat the last command executed
Related commands SPR
SPR_M
SPR_D
SPR_PLANE
SPR2X
EXTEND_END
Internal name