Telling snapping to keep searching

Follow these steps to tell snapping to keep searching when running a command that asks you to select an entity:

  1. Display the Code toolbar and select 010123 LIMITE PROVINCIAL from the drop-down list.
  2. Draw a line in the drawing window by clicking with the mouse's data button. Finish the line with the mouse's cancel button.
  3. Select 020123 CURVA DE NIVEL (FINA) in the same way.
  4. Draw another line in the drawing window that crosses the first one.
  5. Change the cursor size using Change cursor size on the Snap toolbar.
  6. Select Delete selected entities from Edit/Delete selected entities to delete the 020123 CURVA DE NIVEL (FINA) line. In the lower left corner, Digi3D.AI asks you to select the entity to delete.
  7. Place the cursor where the two lines cross and click the middle mouse button. Notice that 010123 LIMITE PROVINCIAL is selected. To switch to the other entity, click the mouse's snap button again to select 020123 CURVA DE NIVEL (FINA). If that is the entity you want to delete, click the mouse's data button to accept the command.
  8. Check that if you click the mouse's snap button more times than there are entities Digi3D.AI can find, it sounds an error.
  9. Press Esc or click the mouse's cancel button to finish the command.

Follow these steps to tell snapping to keep searching when using search modes:

  1. Draw the 020123 CURVA DE NIVEL (FINA) line deleted in the previous procedure again. Draw it near 010123 LIMITE PROVINCIAL, without crossing it and with roughly the same length.
  2. Select 0. Vertex or projection in XY on the Snap toolbar.
  3. Click the mouse's snap button near one end of the two lines to snap to one of them. To snap to the other line, click the mouse's snap button again.
  4. Click the mouse's data button and continue drawing the line.

Video