Edit

Digitizing features orthogonal to a specified angle

Follow these steps to digitize features orthogonal to a specified angle:

  1. Display the Polyline restrictions toolbar. If it is not active, click here to learn how to display it.
  2. Display the Active parameters toolbar. If it is not active, click here to learn how to display it.
  3. Click the third button on the Active parameters toolbar, which corresponds to the active angle, to run AA.
  4. Enter 45 (sexagesimal degrees) in the window at the lower right and press Enter. In the lower left corner, Digi3D.AI asks you to enter an active angle or digitize the first point.
  5. Click the second button on the Polyline restrictions toolbar, Orthogonal to the active angle. When this button is active, digitized lines are orthogonal relative to the stored active angle. The active angle of 45º is measured from the positive X axis.
  6. Draw a line in the drawing window by clicking with the mouse's data button. The first segment forms an angle of 45º to the horizontal, and the remaining segments are orthogonal to each other.
  7. Turn off Orthogonal to the active angle and continue digitizing segments. You can now draw segments in any direction.
  8. Turn Orthogonal to the active angle on or off as often as needed while drawing an entity.

Follow these steps to digitize features orthogonal to a specified alignment:

  1. Display the Polyline restrictions toolbar. If it is not active, click here to learn how to display it.
  2. Display the Active parameters toolbar. If it is not active, click here to learn how to display it.
  3. Click the third button on the Active parameters toolbar, which corresponds to the active angle, to run AA.
  4. Digitize two points to define an alignment. In the lower left corner, Digi3D.AI asks you to enter an active angle or digitize the first alignment point. Click two points in the drawing window with the mouse's data button. If you defined an alignment before running the command, use search mode 4. Nearest vertex in XYZ to select its two vertices. Click here for instructions on changing search modes.
  5. Turn on Orthogonal to the active angle on the Polyline restrictions toolbar.
  6. Start digitizing a polyline. Its first segment uses the angle defined by the alignment, and the remaining segments are orthogonal to it and to each other.
  7. Turn Orthogonal to the active angle on or off as often as needed while drawing an entity.

Video