Edit

Digitizing vertices with different Z coordinates

Digitize vertices with different Z coordinates by entering coordinates. Follow these steps:

  1. Find the Coordinates toolbar. If it is not visible, click here to learn how to display it.
  2. Click the third button on the Coordinates toolbar. It runs XY, which lets you enter coordinates with different Z values.
  3. Enter the following coordinates: 0 0 0, 100 100 10 and 200 0 0, and click OK.
  4. Finish LINE with the mouse.
  5. Check that a polyline with the three vertices you entered has been created in the drawing window.
  6. Select search mode 4. Nearest vertex in XYZ on the Snap toolbar.
  7. Snap near each vertex and check its Z coordinate in the first window on the Snap toolbar.

Follow these steps to digitize vertices with different Z coordinates using the input device:

  1. Find the Z coordinate toolbar. If it is not visible, click here to learn how to display it.
  2. Click the first button on the Z coordinate toolbar. This corresponds to Z.
  3. Enter a Z coordinate in the window at the lower right of the message bar, for example Z=100.
  4. Press Enter to accept.
  5. Find the Coordinates toolbar. If it is not visible, click here to learn how to display it.
  6. Check in the first window on the Coordinates toolbar that Z has changed to 100 m.
  7. Digitize a polyline by clicking the drawing window. Every vertex of the polyline will have a Z coordinate of 100 m.

Follow these steps to digitize a polyline whose vertices have different Z values:

  1. Digitize the polyline's first segment using the current Z coordinate.
  2. Click the first button on the Z coordinate toolbar and enter 200 m as the new Z coordinate.
  3. Press Enter and enter a new vertex.
  4. Finish the polyline with the mouse's cancel button.
  5. Check that search mode 4. Nearest vertex in XYZ is selected. Otherwise, select it from the Snap toolbar drop-down list.
  6. Snap to each vertex to see its Z coordinate.

Follow these steps to change the Z coordinate by snapping with a mode that includes Z:

Clicking the first button on the Z coordinate toolbar activates the second button, locking the Z coordinate (the FIXZ variable). This option is mainly used to digitize contour lines.

  1. Turn off FIXZ (the second button on the Z coordinate toolbar).
  2. Select search mode 2. Vertex or projection in XYZ from the Snap toolbar drop-down list (it changes Z when snapping).
  3. Snap to the middle of a segment digitized in the previous steps and check, in the first window on the Coordinates toolbar, that Z has changed. Vertices digitized after this snap will have the Z coordinate you just obtained.
    • If you select a search mode with Z, such as mode 3, and confirm the snap selection, the vertex is displayed with the segment's coordinate at the point where you snapped.
    • If you select a search mode without Z, such as mode 0, check that the active Z coordinate retains its value from before the snap. If you snap to another point on the segment, the first window on the Snap toolbar shows that point's coordinate, but the active Z coordinate retains its value from before the snap.
  4. Select search mode 4 and snap to the vertices of the polylines you digitized to check their Z coordinates.
  5. Click the second button on the Z coordinate toolbar to activate FIXZ.
  6. Snap to any entity and check that Z remains constant, even if the feature you snap to has a different Z value.

Video