CHNG_COD_E

Change codes by topological enclosure.

Parameters

Does not accept parameters.

Notes

This is a flooding command: it acts on enclosures you click and requires a topology for flooding loaded in memory. Before running it, generate that topology with GENERATE_FLOOD_TOPOLOGY or GENERATE_FLOOD_TOPOLOGY_WITHOUT_ISLANDS, and regenerate it if you modify drawing lines. Without a topology for flooding, the command displays "No temporary topology is created", sounds an error tone, and ends, and Flooding/Change codes is disabled.

  1. Press the data button inside an enclosure to select it. Hold Control to add enclosures to or remove them from the selection.
  2. Press the snap button to replace the last selected enclosure with the next enclosure containing the cursor that is not already selected. If no unselected enclosure contains the cursor, the command removes the last enclosure from the selection and sounds an error tone. With no enclosure selected, the snap button acts like the data button. Press the reset button to clear the selection.
  3. Press the spacebar to apply the change. The command ends after applying it. Press Escape to cancel.

The command changes entities forming the selected enclosures' exterior boundaries:

  1. The command collects codes to change. It takes the code of each entity with a single code. For an entity with multiple codes, it takes none if any is already among the collected codes; if none is, it displays Select code, titled Select the code to change, for you to choose one.
  2. On each entity, it replaces all collected codes with the first active code. If several match, the entity receives a single active code in their place.

Click Cancel in Select code to end the command without changing any entities.

Command characteristics

Command type Interactive command
Repeats automatically No
Menu option Flooding/Change codes
Toolbar This command has no associated toolbar button
Extension DigiNG.OrdenesTopologia.dll
Implementation Native
Related variables No related variables
Related commands DELETE_ENCLOSURE
RENAMCOD_E
Internal name {2D62711E-182D-43e9-BA19-4DFC7CE81D11}