Your first snap
Get to know Digi3D.AI's snaps, or search modes:
- Draw a line with three vertices.
- Draw a new line starting at the middle vertex of the first line.
- Zoom in as far as possible on that vertex by scrolling the mouse wheel up. However far you zoom in, the two vertices will never coincide when you draw the second line. Check the gap between the vertices by zooming in on the area where they should coincide.
- Click Undo on the Undo toolbar to delete the last line drawn.
- Zoom out by scrolling the mouse wheel down.
Draw the second line again using snapping (searching for points on an entity). Follow these steps:
- Click the middle mouse button in an area without any entities. Digi3D.AI sounds an error to indicate that it found no entity in that area.
- Select the entity you drew at the start with the middle mouse button. The entity is highlighted, and an animation shows the direction in which it was drawn.
- Cancel the selection with the cancel button or Esc.
- Find the Snap toolbar and check that search mode 0. Vertex or projection in XY is active. If it is not selected, click the arrow on the right and select it. If you cannot find the Snap toolbar, click here to display it.
- Try snapping to different positions on the entity by clicking the line with the mouse's snap button. In search mode 0. Vertex or projection in XY, Digi3D.AI first tries to find a vertex and, if none is found, tries to find a projection. Click the cancel button to cancel the snap.
- Change the cursor size on the Snap toolbar, either by clicking Change cursor size repeatedly or by clicking the arrow to the right of the button and selecting a size from the drop-down list.
- Move the cursor close to the first entity's middle vertex so you can snap to it.
- Click the middle mouse button and check that the entity's middle vertex is selected.
- Click the mouse's data button to accept the snapped vertex and continue the line.