FIN_ENT

Finish the line being drawn.

Parameters

Does not accept parameters.

Notes

The command acts on the active drawing command, which must support being finished. LINE, POL, SPLINE, TRIM_M, SELECT_POLYGON, SELECT_INSIDE_POLYGON, and SELECT_OUTSIDE_POLYGON support this. If no command is active, or the active command does not support being finished, the error sound plays and nothing else happens.

With LINE:

  • If the line has only one point, it is not stored and LINE finishes.
  • If it has two or more points, it is smoothed if S is enabled, generalized if G is enabled, and closed if C is enabled, before being stored. Duplicate points are then removed.
  • If P is enabled, a parallel copy is also stored at the distance specified by AD.
  • LINE remains active with the same code, so the next point starts a new line.

Use CLOSE_ENT to finish and close the line.

Command characteristics

Command type Immediate command
Repeats automatically No
Menu option Draw/Finish the line being drawn
Toolbar End of the polyline
Extension DigiNG.OrdenesStandard.dll
Implementation Native
Related variables No related variables
Related commands CLOSE_ENT
LINE
Internal name