Internal orientation of the right camera

If you already have one camera's internal orientation, you can perform the other camera's internal orientation fully automatically.

Complete Internal orientation of the left camera before following these steps for the right camera:

  1. Select Photogrammetric window/Inner orientation (right). This runs INNER_ORI_R, which performs the right camera's internal orientation.
  2. Check that the command uses the left camera's internal orientation to measure the right camera's automatically. The Digi3D.AI status bar displays Correlating fiducial mark: N, identifying the mark being sought, and a progress bar that advances with each mark. When Internal orientation appears, the marks found are already measured and only need checking. If correlation fails to find a mark, it stops and the pane requests manual measurement of that mark and the following ones. If all marks are found, Digi3D.AI runs the pane's Worse? action and displays the measurement with the largest error.
  3. If the mark measurements are correct, click OK to finish the right camera's internal orientation. Otherwise, remeasure any incorrect points.

Video