Aerial triangulating the second model
As when performing a project's second absolute orientation, Digi3D.AI does not let you change a point's location in a photo if it has already been measured there.
When a point to be measured in a model has already been measured in the previous model, the program prevents movement in X,Y and allows movement only in Z, locking the image where the point was already measured. This prevents measuring the same point at two different locations.
Complete Files generated when measuring aerotriangulation before continuing.
- Load model 108-109 from the Photogrammetric project pane.
- Click T on the photogrammetric window toolbar.
- Measure point 1080 as requested. It was already measured in photo 108 of model 107-108, so Digi3D.AI prevents movement of the photogrammetric window in X,Y. Change Z to position the pointer stereoscopically over point 1080 and measure it.
- Measure every point specified by the schema.
- Add control points 8 and 9. Remember their locations.
- Click OK.